Magician Race SolutionsSTAGE 2 & STAGE 3 | QUICK START

MRS Installation Instruction Quick Start Guide

MAGICIAN RACE SOLUTIONS

Stage 2 & Stage 3 - Quick Start installation sequence.

  1. Identify your four primary vehicle integration connections: Battery Main power, constant 12V positive; Earth, battery negative; Key ON signal, switched 12V positive, present with ignition on and during cranking; and Key START signal, 12V positive only while the key is held in START.
  2. Disconnect the battery before beginning any wiring work.
  3. Mount the MRS fuse/relay box securely under the dash in a dry, accessible location.
  4. Install the firewall bulkhead hardware that suits your system, then route the harness through the firewall.
  5. Route the engine harness along its intended path and secure it clear of heat, sharp edges and moving components.
  6. Connect all labelled engine-side connectors and confirm each connector is fully seated and locked.
  7. Route and secure the cooling-fan and fuel-pump wiring. Run the fuel-pump wires rearward inside the vehicle under carpet/trim, protected from chafe or pinching, and use the supplied MRS bulkhead boot at the rear pass-through.
  8. Identify the vehicle circuits required for integration using the correct vehicle wiring information. Do not rely on wire colour alone.
  9. Connect the four primary vehicle-integration wires: Main Power - 12V+; Main Earth - Negative (-); Ignition ON - 12V+ switched; Starter Signal - 12V+ when cranking.
  10. Connect the required monitoring and auxiliary circuits: Tachometer / RPM Signal, Factory Oil Pressure Warning Light, Alternator Charge Warning Light, Reverse Lights, Factory Water Temperature and Gauge / Cluster connections.
  11. Before reconnecting the battery, complete continuity checks and verify all electrical connections are correct and secure. Ensure all required fuses are correctly installed.
  12. Reconnect the battery. With ignition ON, complete the pre-start electrical checks and verify the expected power and earth supplies.
  13. With ignition-coil power disconnected, secure and insulate the live coil-power terminal so it cannot contact earth or any conductive part. Crank the engine in short intervals and confirm oil pressure. Switch ignition OFF, then reconnect coil power.
  14. Start the engine and immediately confirm oil pressure. Verify warning lights, gauges and cluster functions operate correctly.
  15. Confirm alternator charging and correct charge-warning-light operation.
  16. Operate the cooling-fan manual override and verify both fans run.
  17. Allow the engine to reach operating temperature and confirm automatic cooling-fan operation.
  18. Complete a final inspection of harness support, connectors, firewall sealing, power/earth connections, fuel-pump wiring and all installed fasteners.