Street
Clean engine-side wiring designed to integrate with the vehicle’s existing relay and fuse arrangement.Engine-side wiring designed to integrate with the vehicle’s existing relay and fuse arrangements.
- TXL wire with expandable braid sheathing and glue lined heat shrink
- Deutsch DT vehicle integration connector
- Separate fuel pump and fan harness with integrated relay and fuse assembly for mounting at the front right-hand side of the engine bay.
Vehicle connections
Uses the vehicle’s existing ignition, starter and alternator relay/fuse arrangements.
Engine harness connections
Connect the following vehicle circuits through the supplied engine-bay Deutsch DT connector:
- ignition and starter relay outputs,
- alternator sense (S) and charge warning lamp (L),
- both reverse switch wires,
- factory water temperature gauge and
- factory oil pressure warning light.
- rev counter
Vehicle-side terminal crimping is required. Refer to the installation instructions for wiring and pin locations.
Fuel pump and fan harness connections
Connect the relay/fuse assembly at the front right-hand side of the engine bay
- to a direct battery feed, fused close to the battery.
- Connect its earth lead preferably to battery negative, or to a suitable clean, bare-metal chassis earth point.
Aftermarket gauge connections
Power, earth and sender signal wiring for the aftermarket gauges is already integrated into the harness. Connect gauge illumination separately to the vehicle’s lighting switch circuit.
- oil pressure
- oil temperature
- water temperature
Refer to the installation instructions for wiring details.





