INSTALLATION GUIDEStage 1 Street Quick Start
MRS Installation Instruction Quick Start Guide
MAGICIAN RACE SOLUTIONS
Stage 1 Street - Quick Start installation sequence.
Quick Start
Use this page as the installation sequence. The full instructions explain each step in more detail.
- Identify your four primary vehicle integration connections: Battery Main power, constant 12V positive; Earth, battery negative; Key ON signal, switched 12V positive, present with ignition on and during cranking; and Key START signal, 12V positive only while the key is held in START.
- Disconnect the negative battery terminal before beginning any wiring work.
- Identify the main engine harness, coil-to-distributor subloom, separate fan and fuel-pump harness with integrated fuse/relay assembly, and alternator charge cable.
- Identify the vehicle ignition, starter and instrument-cluster circuits using the correct vehicle wiring information.
- Mount the fully prewired fuse/relay assembly at the front right-hand side of the engine bay, securely and clear of excessive heat and water.
- Connect labeled main battery power and earth. Fit the main battery fuse close to the battery, with rating and arrangement per the approved schematic.
- Lay the engine harness along the contours of the engine, using labeled branches and plugs as guides; secure clear of heat and moving parts.
- Route the combined cabin section through the firewall grommet; gauge, cluster, fan-override and fuel-pump wiring are integrated.
- Connect labeled engine-side plugs, including the alternator L/S connector (S circuit protected by a 5 A fuse), starter trigger, senders and reverse switch.
- Install the separate alternator charge cable from alternator B+ to the starter battery-positive stud; secure and protect its routing.
- Install the coil-to-distributor subloom and connect both coils and the distributor.
- Route fan and fuel-pump branches. Terminate supplied mating 2-pin Deutsch DT plugs onto component wires and connect, checking polarity.
- Connect the vehicle integration DT plug, cabin manual fan override switch, automatic fan temperature switch, gauges and factory cluster circuits.
- With the battery disconnected, check connector seating, continuity, absence of shorts, fuse ratings, power/earth and ignition/starter wiring against the schematic.
- Reconnect battery. Key ON without cranking: confirm 12 V at both coil positives, charge and oil warning lamps illuminated, and gauges powered.
- With starter solenoid trigger disconnected, confirm 12 V at the trigger only while key is held in START; key OFF and reconnect.
- Start engine; confirm oil and charge warning lamps extinguish and tachometer responds. Test manual and automatic fan switching; verify both fans spin correctly.
- Verify fuel pump runs with key ON and stops with key OFF. Warm engine stationary, check instruments and charging voltage, then key OFF and recheck harness security.
IMPORTANT
Do not rely on wire colour alone when integrating the MRS system into the vehicle. Identify factory circuits using the correct vehicle wiring information and confirm electrically where practical.